Baking soda particles can clog your vacuum, are difficult to remove, and act in a similar way to sandpaper when caught in carpet fibres..
You don’t need to whack the filter – a gentle tap is enough!.If there is still visible dirt on the filter after tapping it off, you’ll need to clean it:.
Rinse the filter under a. cold tap.until the water runs clear.Do not use hot water or any detergent.. Gently squeeze out excess water (not too hard though!).
Allow the filter time to.before replacing it in the bin.
In most cases, we recommended leaving the filter to air dry for around 24 hours.. It’s vital not to put a wet (or even damp) filter back into the Gtech Multi Mk2.
Doing so could allow water to reach the motor, which can cause serious damage (and risk an electric shock).. A damp filter is also the perfect environment for mould and milder to grow..Don’t try to force them into a straight position!.
Step 5: Fully Charge The Vacuum.A new Dyson battery will only be partially charged, so it’s important to fully recharge it before first use.. Once the battery is fully charged, you’re ready to use your vacuum again!.
Frequently Asked Questions.Can The Dyson V10 Battery Be Replaced?.